Loading ...
Loading ...
Loading ...
10 11
INSTALLATION INSTRUCTIONS (continued) ELECTRICAL CONNECTION
LEVEL RANGE
HOW TO LEVEL THE RANGE:
1. To level your range, place a level straight across (left to right), on one of the racks inside
your oven. If the range is uneven, adjust the leveling legs until the level is balanced. (Lev-
eling legs are on the bottom of the range and can be adjusted by turning feet clockwise
or counterclockwise.
2. Once you have checked the levelness from left to right, take another reading by moving
the level and placing itdiagonally across the bottom of the oven. If the range is still
uneven, adjust the leveling legs again until all angles on the level are balanced.
This oven is manufactured with a neutral
(white) power supply wire and a cabi-
net-connected green (or bare) ground wire
twisted together.
A. To access the terminal block, remove
the terminal block cover by removing
screws using a phillips screwdriver.
Donot discard these screws.
B. For power cord and 1" conduit only,
remove the knockout ring [1-3/8" (3.5
cm)] located on bracket directly below
the terminal block. To remove the
knockout, use a pair of pliers to bend
the knockout ring away from the brack-
et and twist until the ring is removed.
C. For power cord installations only (see
the next step if using conduit), assem-
ble the strain relief in the hole. Insert the
power cord through the strain relief and
tighten. Allow enough slack to easily
attach the cord terminals to the terminal
block. If tabs are present at the end of
the winged strain relief, they can be
removed for better fit.
Screw to remove
Terminal Block Cover
Terminal
Block Cover
NOTE: Do not install the power cord with-
out a strain relief. The strain relief bracket
MUST be installed before reinstalling the
terminal block cover. You Must purchase a
cord at thedesired length that matches the
receptacle configuration correctly.
NOTE: Next to this knockout ring [1-3/8"
(3.5 cm) ], a knockout ring [1-1/8" (2.9 cm])
is reserved for installation to match some
models of power cord and conduit.
D. For 3/4" conduit installations only, pur-
chase a squeeze connector matching
the diameter of your conduit and as-
semble it in the hole. Insert the conduit
through the squeeze connector and
tighten. Allow enough slack to easily
attach the wires to the terminal block.
NOTE: Do not install the conduit without a
squeeze connector.
Terminal Block
(appearance
may vary)
Knockout
Ring in
Bracket
Knockout
Ring Removed
ELECTRICAL SHOCK HAZARD
• Disconnect power before servicing.
• Use a new 50 amp power supply cord.
• Use 8 gauge copper or 6 gauge aluminum wire.
• Electrical ground range.
• Plug into a grounded outlet.
• Failure to follow these instructions can result in death,
fire or electrical shock.
Loading ...
Loading ...
Loading ...