Loading ...
Loading ...
Loading ...
Troubleshooting en
25
▶
If the power cord of this appliance is damaged, it
must be replaced by trained specialist staff.
21.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not working. The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
"Sprache Deutsch" appears in
the display.
There has been a power cut.
▶
Implement the settings for the initial configuration.
– Language
– Clock
The operation does not start or is
interrupted.
Different causes are possible.
▶
Check any notifications that appear in the display.
→"Displaying information", Page12
Malfunction
▶
Call the after-sales service.
→"Customer Service", Page27
Appliance does not heat up. Demo mode is activated in the basic settings; appears in the display.
1.
Briefly disconnect the appliance from the power supply by switching the cir-
cuit breaker in the fuse box off and back on again.
2.
Deactivate demo mode within three minutes in the
→"Basic settings", Page18.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance is checked and is ready to use.
The time is not displayed when
the appliance is switched off.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→"Basic settings", Page18
The control ring has fallen out of
the mount in the control panel.
The control ring has been detached.
1.
Insert the control ring into the mount in the control panel.
2.
Push the control ring into the mount so that it clicks into place and can be
turned.
The control ring is difficult to turn. There is dirt below the control ring.
The control ring can be removed.
Note:To ensure that the mount remains stable, do not remove the control ring
too often.
1.
To loosen the control ring, press on the outer edge of the control ring.
a The control ring tilts and is easier to grip.
2.
Remove the control ring from the mount.
3.
Clean the control ring and its mount on the appliance carefully using soapy
water and a dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The interior lighting does not
work.
The halogen lamp is defective.
▶
Change the oven light bulb.
→"Replacing the oven light bulb", Page26
Loading ...
Loading ...
Loading ...