Loading ...
Loading ...
Loading ...
15
Cleaning and Maintenance
TROUBLESHOOTING
Cleaning
• To clean, wipe with a soft, slightly moist cloth.
• Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp
utensils to clean the product.
Maintenance
• Check the components regularly to make sure all screws and bolts are tightened.
• Store in a cool and dry place away from children and pets, ideally in original
packaging.
Possible Cause
Problem Corrective Action
The pump
will not
start or run
The pump
will not
prime or
retain prime
after
operating
Flow rate too
low
The seal
leaks
1. There is a blown fuse or tripped
circuit breaker in your home's
breaker/fuse box.
2. The voltage is low.
3. The impeller is blocked.
4. The motor is defective.
1. The piping or hose is block or
damaged.
2. The voltage is low.
3. The hose diameter is too small.
4. The discharge hose is too small.
1. The seal is worn,or the shaft is
grooved,or the pump head is loose
on the motor.
1. Call for replacements.
1. If blown, replace with a proper sized
fuse or reset the breaker.
2. If the voltage is less than 108 Volts,
check the wiring size or use a shorter
extension cord.
3. Remove the blockage.
1. Clean or replace the piping or hose.
2. If the voltage is less than 108 volts,
check the wiring size or use a shorter
extension cord.
3. Use a minimum 3/4" (1.9 cm) heavy
duty garden hose.
4. Use as short a hose as possible
(maximum of 50' (15 m)).
1. Repair or replace the inlet line.
2. Remove the blockage.
3. Replace the seal.
4. Lower the pump.
5. Straighten the hose.
6. Tighten the fittings.
7. Submerge the suction hose end.
8. Clean the inlet.
1. There is an air leak in the inlet line.
2. The impeller is blocked.
3. The seal is worn.
4. The inlet lift is too high.
5. The hose is kinked or looped.
6. The fittings are not tight.
7. The inlet hose is out of water.
8. The inlet is clogged.
Loading ...
Loading ...
Loading ...