Loading ...
Loading ...
1. Separate the gem bar (AA) from the fixture canopy (A) by removing
two canopy screws (DD).
3. Make all wire connections to appropriate wire. Secure with wire
nuts (CC – provided). Connect the green wire from the fixture to
the supply power source ground wire. Connect the black wire from
the fixture to the black (L) wire from supply power source. Connect
the white wire from the fixture to the white (N) wire from supply
power source. Do not mix wires. Pull on each wire lead to make
sure connections are secure. Make certain no bare wires are
exposed outside of wire connectors. Tuck all connections neatly
into the junction box.
2. Mount gem bar (AA) to the junction box (not included) using two
junction box screws (BB) (provided).
Wiring – all wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box.
Check power wires for damage or scrapes. If power supply wires
are within three inches of the LED driver, use wire suitable for at
least 90°C (194°F). Note: Most dwellings built before 1985 have
supply wire rated to 60°C. Consult a qualified electrician to ensure
correct branch circuit conductor before installing.
4. Mounting
Place fixture canopy (A) over the gem bar (AA) and align the
mounting holes on both sides of the canopy. Secure the fixture
using two canopy screws (DD).
Power to the fixture may now be restored.
ASSEMBLY INSTRUCTIONS
3
3
2
1
A
CC
AA
BB
AA
A
DD
DD
4
AA
Loading ...