Loading ...
2
PREPARATION
Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture.
Carefully remove the fixture from the carton, and check that all parts are included.
If parts are missing or damaged, do not attempt to assemble the product. Contact customer service at 1-800-873-2326
Monday - Friday, 8:00 am-4:30 pm Central Standard Time for replacement parts.
Estimated assembly time: 30 minutes.
SAFETY INFORMATION
Read all safety precautions and installation instructions carefully before installing or servicing this fixture. Failure to comply
with these instructions could result in potentially fatal electric shock and/or property damage.
It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance with all national and
local electrical codes.
WARNING: Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a
wet or damp surface or in water.
WARNING: To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately
grounded. To accomplish proper grounding, there must be a separate ground wire (green) contact between this fixture and
the ground connection of your main power supply panel.
WARNING: This product can expose you to lead, which is known to the State of California to cause cancer, birth defects
or other reproductive harm. For more informaton go to www.P65Warnings.ca.gov
CAUTION: This fixture is designed for use in a 120VAC, 60Hz fused circuit and can be used in conjunction with most 2-wire,
triac dimmers. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
MINIMUM 90˚C SUPPLY CONDUCTORS.
This fixture is intended to be used for general indoor lighting in dry or damp locations only.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules and Canadian ICES-005. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modifications to this fixture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Loading ...
Loading ...