Loading ...
Loading ...
Loading ...
Washer drum contents
Two AquaShield ® water supply hoses are shipped in
the washer drum. Be sure to remove each of these items
from the drum before using the washer.
÷
Hot water AquaShield ® hose
Cold water AquaShield ® hose
NOTICE; If any parts are missing please notify your
dealer immediately.
Set up on a pedestal with drawer
Pedestal item number: WMZ 20490
Mount washer on the pedestal according to the
instructions in the installation kit.
Installation checklist
Review the following list and check off each step as it is
completed during installation.
,/ Installation Step
If installing to a pedestal
(base), complete the base
installation before removing
the transportation bolts
Completely remove all four
shipping bolts keeping the
bolt and bushing assem-
blies intact
Connect the water supply
hose and drain hose
Connect the electrical
power
Slide the washing machine
into its final location
Level the washing machine
(as low as possible)
Page
-_> Remove the trans-
port bolts; Page 12
-_> Remove the trans-
port bolts; Page 12
-_> Water
connections; Page 13
-_> Electrical
connection; Page 16
Leveling the
washer; Page 15
12
,/ Installation Step Page
Before washing laundry, run -_> Before loading
the Drum Clean program your first load of
laundry; Page 19
Importance of installing on a solid, level
floor
Your new Bosch washing machine utilizes high spin
speeds to achieve superior water removal from your
laundry resulting in reduced drying time. It is important to
install your washing machine on a floor that will provide
firm support. This prevents the washer from experiencing
excess vibration during spinning that could cause the
washer to move or be noisy.
The installation surface must be solid and level in both
directions. Avoid installing your washer on soft surfaces
such as floors with carpet or foam backed covering
material.
If installing the washer on a wooden floor, observe the
following:
o install the washer in a corner for better support if
possible.
o if necessary, reinforce the floor by screwing a water
resistant wooden board to the floor (minimum of
1.18 in./30 mm thick).
Remove the transport bolts
• , CAUTION
DAMAGE TO THE APPLIANCE OR INJURY
POSSIBLE
o The machine is secured for transport with
transport bolts.
Transport bolts that are not removed can damage
the drum during operation of the machine, the
washer will vibrate, and it will be much noisier
during spin cycles if the transport bolts are not
removed before use.
Be sure to remove all 4 transport bolts
completely before first use. Keep the transport
bolts.
If a pedestal was purchased with the washer, it
must be installed first, prior to removing the
transport bolts. Please consult the pedestal
installation instructions.
o In order to prevent transport damage during later
transport, be sure to re-install the bolts before
transport.
Loading ...
Loading ...
Loading ...