Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Locating your Appliance
• Install the appliance in a dry and well ventilated room. The appliance will operate correctly if the
environment temperature is in the interval specified in the table. The appliance class is indicated
on the rating label with the basic information on the appliance.
Description
Class
Ambient temperature range °F
Relative humidity
Extended temperate
SN
+50 to +90
75%
Temperate
N
+61 to +90
Subtropical
ST
+61 to +100
Tropical
T
+61 to +109
CAUTION: Do not place an appliance in a room where temperature can drop to below 41 °F as this
may cause abnormal appliance operation or failure!
• After the installation, the main
power plug should be accessible.
• This appliance is not intended to
be used as a build-in appliance.
The appliance is intended for
free-standing installation. To
reach the rated/ minimum power
consumption, always provide 50
mm of clearance between the
wall and the back of the
appliance, and above the
appliance. Also allow adequate
air circulation on either side of
the appliance and above it.
• The appliance can also be
placed adjacent to or between
kitchen cabinets or cupboards, or
adjacent to a wall. In case of such placement, the appliance will operate flawlessly; however,
power consumption could increase. Observe the minimum clearance above and behind the
appliance, as indicated in the figure.
• Consider the space or clearance required to open the appliance door, in order to allow the
drawers and shelves to be pulled out or removed (see installation diagram).
• Do not place the appliance near appliances or devices radiating heat, such as a stove, a
radiator, water heater etc., and do not expose it to direct sunlight. The appliance should stand at
least 3 cm away from an electric or gas cooker or at least 30 cm away from an oil or solid fuel
stove. If the distance between such source of heat and the appliance is smaller, use an
insulating panel.
• On the upper part of the appliance the air is coming out, so try not to cover the opening for the
outflow air. Ignoring this caution may result in damage to the appliance.
Note: Place the appliance in a sufficiently large room. There should be at least 1 m3 of space per 8
grams of refrigerant. Amount of refrigerant is indicated on the rating plate in the appliance
interior. At the base of the kitchen unit intended for building in the integrated appliance, there
should be at least 200 cm
2
free space, for adequate air circulation.
Loading ...
Loading ...
Loading ...