Loading ...
Loading ...
Loading ...
9
Oil warning light (red)
When the oil level falls below the lower level, the oil warning light comes on and then the engine stops
automatically. Unless you refill with oil, the engine will not start again.
Tip: If the engine stalls or does not start, turn the engine switch to "ON" and then pull the recoil starter.
If the oil warning light flickers for a few seconds, the engine oil is insufficient. Add oil and restart.
Overload indicator (red)
When the overload indicator is on, it indicates that the generating set is overload and then the AC
protector works. It will stop the output of generating set to protect the electric equipment and the
generating set itself. At this time, the running indicator (green) is off and the overload indicator (red) is on,
but the engine is still in running state.
When the generating set has no output and the overload indicator is on, please take the following steps:
1. Lower the total power of the connected electric devices to the rated output range of generating set.
2. Check the air intake for impurities and check the control parts for abnormal situation. Handle
immediately if necessary.
3. Press the reset button.
Running indicator (green)
The output indicator lights up when generating set starts and has normal output.
Note: If engine flames out or fails to start, turn the combination switch to “RUN” position and then pull
the recoil starter. If the oil alarming lamp lights up, it shows lack of oil. Please add appropriate oil and
restart the engine.
Loading ...
Loading ...
Loading ...