Loading ...
Loading ...
Loading ...
17
INSTALLATION INSTRUCTIONS
Compatible blowers
This range hood may only be used in connection with these internal or inline blowers:
Internal blowers come with the range hood (for HCB30/36/48 range hood models).
Inline blowers can be purchased separately (for HC36/48 range hood models). This
range hood may only be used with a Fisher & Paykel approved inline blower.
To minimize noise in the kitchen, these blowers are mounted along the duct line
anywhere between the kitchen and the exterior wall.
CAUTION!
To reduce the risk of fire and electric shock, install this range hood only with remote
blower models rated maximum 7.6A or integral blowers supplied with the range hood.
WARNING!
This appliance is heavy and requires two persons for unpacking and installation.
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage
caused by not following these instructions.
Before you start installation
Ensure you have read the ‘Installation
preparation’ section of this guide.
Read the install instructions carefully.
Unpack the range hood.
Ensure the voltage (V) and the frequency (Hz)
indicated on the serial plate match the voltage
andfrequency of the installation site.
Check that the area above and behind the
installation surface is clear of any electrical
cablesor pipes and there is proper clearance
forthe ducting.
The range hood surfaces can be damaged
during installation if grazed or knocked by tools.
Protect the cooktop to prevent damage
occurring whilst the range hood is being
installed above.
Remove protective wrappings that will not be
accessible after installation.
The wall or cabinet used for mounting the
range hood should have sufficient strength and
a flat surface.
EN
Loading ...
Loading ...
Loading ...