Loading ...
Loading ...
Loading ...
• Disconnect the appliance from the
mains supply.
• Cut off the mains electrical cable
close to the appliance and dispose of
it.
3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Before the installation
Before you install the hob, write down the
information below from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
3.3 Connection cable
• For a single phase or two phase
connection, use the cable type:
H03V2V2-F or H05BB-F which
withstands a temperature of 90 °C or
higher.
• To replace the damaged mains cable,
use the cable: H03V2V2-F or H05BB-
F which withstands a temperature of
90 °C or higher. Contact an
Authorised Service Centre. The
connection cable may only be
replaced by a qualified electrician.
3.4 Attaching the seal - On-
top installation
1. Clean the worktop around the cut out
area.
2. Attach the supplied 2x6mm seal
stripe to the lower edge of the hob,
along the outer edge of the glass
ceramic. Do not stretch it. Make sure
that the ends of the seal stripe are
located in the middle of one side of
the hob.
3. Add some millimetres to the length
when you cut the seal stripe.
4. Join the two ends of the seal stripe
together.
3.5 Assembly
Refer to the installation booklet for
detailed information on how to assemble
your hob.
Follow the hob connection diagram and
the window switch connection diagram
presented in the installation booklet and /
or the labels under the hob.
min.
50mm
min.
500mm
If the appliance is installed above a
drawer, the hob ventilation can warm up
the items stored in the drawer during the
cooking process.
830
515
250
80
515
480
442
55
830
770
500
212
7
22
9
16
98
254
www.aeg.com8
Loading ...
Loading ...
Loading ...