Loading ...
Loading ...
Loading ...
Coilelementsshouldbelevelforoptimalcookingresults.Burner
bowls,whenclean,reflectheatbacktothecookware.Theyalso
helpcatchspills.
Cookwareshouldnotextendmorethan1in.(2.5cm)overthecoil
element.Ifcookwareisunevenortoolarge,itcanproduceexcess
heatcausingtheburnerbowltochangecolor.Formore
information,seethe"GeneralCleaning"section.
NOTE:Beforeremovingorreplacingcoilelementsandburner
bowls,makesuretheyarecoolandthecontrolknobsareinthe
Offposition.
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
The lift-up cooktop provides easy access for cleaning beneath.
Do not drop the cooktop. Damage could occur to the finish and
the cooktop frame. For more information, see the "General
Cleaning" section.
To Lift:
Lift the cooktop by both front corners until the supports lock into
place.
2=
Pull the coil element straight away from the receptacle.
3. Lift out the burner bowl.
To Replace:
1. Line up openings in the burner bowl with the coil element
receptacle.
To Replace:
1. Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2. Slowly lower the cooktop into place.
When canning for long periods, alternate the use of surface
cooking areas, elements or surface burners between batches.
This allows time for the most recently used areas to cool.
• Center the canner on the grate or largest surface cooking area
or element. Canners should not extend more than 1 in. (2.5
cm) outside the cooking area.
• Do not place canner on 2 surface cooking areas, elements or
surface burners at the same time.
• On ceramic glass models, use only flat-bottomed canners.
• On coil element models, the installation of a Canning Unit Kit
is recommended. If a kit is not installed, the life of the coil
element will be shortened. See "Assistance or Service" for
ordering instructions.
• For more information, contact your local U.S. Government
Agricultural Department Extension Office. In Canada, contact
Agriculture Canada. Companies that manufacture home
canning products can also offer assistance.
2. Holding the coil element as level as possible, carefully push
coil element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it will
go, push down the edge of the coil element opposite the
receptacle.
Loading ...
Loading ...
Loading ...