Loading ...
Loading ...
Loading ...
www.bissell.com
Troubleshooting
16
Reduce spray or no spray
Possible causes Remedies
1. Make sure power is on 1. Press power button if needed
2. Solution tank may be empty 2. Fill tank according to directions
3. Tank may not be seated properly 3. Turn ON/OFF, heater and wet clean button off.
Remove and reseat tank
4. Hose solution line may be disconnected 4. Check connection at front of machine
5. Wet clean is not turned on 5. Depress wet clean button to turn on
Machine is not suctioning
Possible causes Remedies
1. Collection tank may not be placed properly 1. Open Quick Release
™
Hose Door, lift out tank and
re-seat. Re-latch Quick Release
™
Hose Door
2. Collection tank may not be 2. Check to make sure the top lid is
assembled properly properly seated
3.
Wand tool connections are not tight
3. Check all connections (At grip, wand and tool)
Push tight if necessary.
4.
Collection tank is full
4. Empty collection tank by following instruction on page 9
5.
Float has tripped
5. Check to see if tank needs to be emptied. Make sure
float is down towards bottom of tank.
6.
Pre-motor filter is dirty
6. Remove top lid. Remove and clean pre-moter filter by
following instructions on page 15. Filter must be
completely dry before using again
Built-in heater light does not illuminate
Possible causes Remedies
1. The heater button has not been depressed 1. Depress the heater button
2. The ON/OFF button has not been depressed 2. Depress the ON/OFF button
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
WARNING:
To reduce the risk of fire, electric
shock, or injury unplug from outlet
before servicing.
Loading ...
Loading ...
Loading ...