Loading ...
Loading ...
Loading ...
49-2001105 Rev. 0 13
CARE AND CLEANING
6SDUN,JQLWHUDQG(OHFWURGHV
The electrode of the electronic ignition system is positioned
at the rear of the burner base. When cleaning the cooktop,
be careful not to snag the igniter with your cleaning cloth.
Damage to the igniter could occur.
Be careful not to push in a control knob while cleaning. It
could cause the igniter to spark.
Make sure that the white ceramic
igniters on the cooktop are dry
and clean. Clean the metal
portion of the electrode with a
soft cloth or emery board.
Do not attempt to remove the
HOHFWURGHIURPWKHFRRNWRS
Burner Grates
Manual Cleaning
Grates should be washed in hot, soapy water and rinsed
with clean water. To soften burned-on food, place grates
in a solution containing ¼-cup of household ammonia
for several hours. Afterward, scrub grates with a plastic
scouring pad soaked in hot, soapy water. Rinse well and
dry.
Oven Cleaning
Some models have grates that can be cleaned in a self-
cleaning oven. If grates do NOT have rubber bumpers
(pads) attached to the bottom of the grates, they may be
cleaned in the oven using the self-clean cycle. See your
oven's Owner's Manual for specific instructions. If self-
cleaning instructions are not mentioned in Owner's Manual,
the grates should not be cleaned in a self-cleaning oven.
'XDOIODPH6WDFNHG%XUQHUVDQG0XOWL5LQJ%XUQHU&RQW
Cleaning
Lift off burner parts only when cool. Wash in hot, soapy
water. You may use a plastic scouring pad to remove burned-
on food particles.
To remove burned-on food, soak the burner heads in a
solution of mild liquid detergent and hot water for 20–30
minutes. For more stubborn stains, use a plastic scouring
pad or toothbrush.
NOTE: Do not use steel wool or scouring pads to clean
the burner parts as these may clog the openings. Never
wash burner heads in your dishwasher. Doing so may
cause them to discolor.
The ports in the burner heads must be kept clean at all times
for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not allow
the burner to operate properly.
After Cleaning
Before replacing the burner parts, shake out excess water
and then dry them thoroughly.
To replace the burner parts:
Make sure that the burner parts are replaced in the correct
location.
1. Replace the burner head on top of the burner base,
making sure that the hole in the burner head is properly
aligned with the electrode in the burner base. A small
gap between the base and head is normal.
2. Place the burner cap on top of the burner head. Make
sure that the burner cap is properly seated on the burner
head.
Burner cap not properly seated
Burner cap properly seated
Clean this metal part
with an emery board.
Do not clean this white
ceramic part with an
emery board.
Loading ...
Loading ...
Loading ...