Loading ...
Loading ...
Loading ...
12 49-2001105 Rev. 0
CARE AND CLEANING
&RRNWRS6XUIDFH
Do not use oven cleaners, abrasive cleansers, strong liquid
cleansers, steel wool, plastic scouring pads, or cleaning
powders on the cooktop surface. Clean with a mild soap
DQGZDWHURUDVROXWLRQRIYLQHJDUDQGZDWHU5LQVH
with clean water and dry with a soft cloth. When cleaning
surfaces, make sure that they are at room temperature and
not in direct sunlight.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool, then
clean and rinse.
Cleaning Knobs
For easier cleaning, the control knobs may be removed by
pulling them directly upwards once the knobs are in the
OFF position. The knobs can be washed by hand with soap
and water.
Do not submerge the knobs under water. If water collects
under the glass from underneath the knob, it will drain out
within 24 hours.
To replace knobs after cleaning, align the hole on the knob
backside with the gas valve shaft and push downward
until the knob is securely fastened. All knobs are
interchangeable.
Stainless Steel Surfaces
Do not use a steel-wool pad; it will permanently scratch the
surface.
To clean the stainless steel surface, use warm sudsy water
or a stainless steel cleaner. Always wipe the surface in the
direction of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool, then
clean and rinse.
To inquire about purchasing stainless steel appliance
cleaner, please call our toll-free number, 800.626.2002 or
visit monogram.com.
Timer Surface (on some models)
Use a damp cloth to clean the glass.
'XDOIODPH6WDFNHG%XUQHUVDQG0XOWL5LQJ%XUQHU
The burner consists of three parts: the burner base, burner
head, and burner cap. The burner head and burner cap
can be lifted off, making them easy to clean.
CAUTION
DO NOT OPERATE THE BURNER
WITHOUT ALL BURNER PARTS IN PLACE.
Surface burners should be cleaned routinely, especially
after bad spillovers, which could clog the slots and holes in
the burner heads.
The electrode is located at the rear of each burner. Do not
attempt to disassemble or clean around any burner while
another burner is on. An electric shock may result.
To remove the burner parts:
1. Turn all controls OFF before removing any burner parts.
2. When cool, you may lift off the burner grates, burner caps
and burner heads for easier cleaning. Do not remove
the burner bases.
Pull the knob straight up off the stem.
Multi-Ring BurnerDual-flame Stacked Burner
Cap
Cap
Electrode
Burner
Burner
Head
Burner
Base
Electrode
Burner
Cap
Loading ...
Loading ...
Loading ...