Loading ...
Loading ...
Loading ...
Using a
screwdriver,
tighten the
screw,
Wrap the power
cord around the
upper and lower
cord hooks and
lock the power
cord plug unto
the power cord.
CAUTION
Do not overtighten.
Overtightenlngcould stripthe screwholes.
Do natoperate thecleaner withoutthescrewln
• place.
TOSTART
CORD ASSEMBLY
Make sure the quick release upper cord hook is in
the upright position, Remove the wire tie from the
power cord,
Lock the cord into
place by forcing it
into the locking
notch on the body
of the upper cord
hook as shown. This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
1. Turn the quick
release cord hook
to either side and
down to release
the power cord.
2. Release the power cord plug from the power cord
and pull the cord off the upper cord hook. Check to
be sure the power cord isstill locked into the lock in
the upper cord hook.
3. Check to see if the cleaner has a bag installed
(See page 11).
NOTE:To reduce the riskof electric shock, this
vacuum cleaner has a polarized plug, (one blade is
wider than the other). This plug will fit in a polarized
outlet only one way. Ifthe plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do
not change the plug in any way.
4. Plug the polarized power cord into a 120-volt
outlet located near the floor.
PersonalInjury and Product Damage Hazard
• DO NOT plug in ifswitch isin ON position.
Personalinjury or damage could result.
• DO NOT use outletsabove counters. Damage
to itemsin surroundingarea could occur.
i
i, I
Loading ...
Loading ...
Loading ...