Loading ...
Loading ...
Loading ...
16
Fig. 16-3 Post base option
INSTALLATION
It is not required to remove the control panel or knobs
to install this unit.
DO NOT lift the unit from the control panel when installing.
PREPARE FOR INSTALLATION
Consult a qualified professional installer.
The flex connector can be routed out the back of the post,
under the post base, or inside the post.
To gain access to the inside of the post, unscrew and carefully
open the access plate on the rear of the post using a medium
Phillips-head screwdriver. Retain the screws.
ROUTE FLEX CONNECTOR
The gas supply line will need to be run to the post install
location as appropriate for the desired setup.
To route flex connector through rear of post:
1. Remove a knock-out disk at the bottom of the access plate
with a large flathead screwdriver. (Insert the screwdriver
into the notch provided in the center of the knock-out.)
2. Remove the plastic grommet (attached to the flex
connector) and insert it into the newly created opening.
Then route the flex connector through the opening. See
Fig. 16-1 and 16-2.
To route flex connector beneath post base:
Route the flex connector through the hole found beneath the
center of the post base (see Fig. 16-3).
Fig. 16-1 Access plate view & install orientation
Access
plate
Fig. 16-2 Post interior detail
Gas supply knock-out
(grommet installed)
Flex
connector
(w/ adapter)
Back of
timer valve
Flex
connector
(w/ adapter)
Regulator
PATIO MOUNT INSTALLATION
Loading ...
Loading ...
Loading ...