Loading ...
Loading ...
Loading ...
Care and Cleaning
Built-In Refrigerators
Using
the Master
Light switch
This feature turns off the lights in the fresh food
and freezer compartments.
The switch is located behind the grille panel
at the top of the refrigerator. Lift up the panel
to access the switch.
Theswitch is located
behindthegrille panel.
Type 1 bulb
replacement
NOTE:Before replacing the bulbs, review
the light bulb information and WARNING.
Replacing Tgpe 1 bulbs located in lamps
behind the top pan in the fresh food
compartment and the bottom freezer basket
in the freezer compartment:
i.
.
Set the Master Light switch to the OFFposition
(seeUsing the Master Light switch) and allow
the lamps to cool.
To access the lamps in the fresh food
compartment, remove the Humidity Control
pan. See Drawer and Pan Remova! section.
Raisethe lid of the pan up to expose
the light cover.
To access the lamps in the freezer
compartment, remove the bottom freezer
basket. SeeFreezer Baskets section.
3.
.
On the back wall there is a curved light
shield. Grasp each end of the light shield.
Pull the shield toward gou and the tabs
on the shield will release from the slots
in the housing.
Remove the glass above the bulbs bg pulling
it straight out.
NOTE:Alwags follow bulb manufacturer's
directions for handling and replacing bulbs.
5. Remove the bulb bg holding the base and
pulling straight up. Replace with a new bulb.
6. Replace the glass bg sliding it into place.
Then replace the light shield bg resting the top
lip of the shield on top of the light housing.
Then press the sides until the tabs pop into
the slots in the housing.
-&WARNING - Thelight shield
must be replaced or the heat from the bulb
could damage the refrigerator.
_ IAVERTISSEMENT :
Vous devez remettre en place I'@cran(_lumi@re
pour ne pas endommager votre r@frig_rateur
avec la chaleur produite par I'ampoule.
7. Resetthe Master Light switch to the ON
position.
21
Loading ...
Loading ...
Loading ...