Loading ...
Loading ...
Loading ...
A B
C D
E
F
G
MACHINE MAINTENANCE – 37
MACHINE MAINTENANCE
Cleaning the Upper Cutter Area
Turn o the main power switch and unplug the machine.
Cleaning the Feed Teeth
Open the front cover.
With a forward brushing movement, use the lint brush to re-
move any lint.
Note: You may use a vacuum cleaner to clean the upper knife
area or feed teeth.
Turn o the main power switch and unplug the machine.
Deactivate the stitch nger by setting it in “R” position (A).
Open the side and front covers.
Remove the needle(s) and the presser foot.
Remove the set screw (B) with the large screw driver. Re-
move the needle plate.
Use the lint brush to remove any lint from around the feed
teeth (C).
Place the stitch plate over the feed teeth, making sure the tab
of the stitch plate (D) is inserted under the edge of the cov-
er (E). The hole in the stitch plate (F) should align with the
knob on the machine (G).
Replace and tighten the set screw.
Attach the needle(s) and the presser foot.
Close the side and front covers.
An overlock requires more frequent maintenance than a conventional sewing machine for two reasons:
• A lot of lint is produced when the cutters are cutting the fabric.
• An overlock runs at a very high speed and needs to be oiled frequently to lubricate the internal working parts.
Storage
When the machine is not in use, be sure to keep it unplugged. Store the machine, so it is not exposed to direct sunlight or hu-
midity.
Servicing
If you have any questions regarding service and/or operation, contact our Customer Care department.
Loading ...
Loading ...
Loading ...