Loading ...
Loading ...
Loading ...
K
L
N
M
G
H
I J
GETTING READY TO SEW – 17
Set the Threading/Sewing switch to “Threading” position
(G) by turning it to the right.
Turn the handwheel slowly toward you until the mark on
the wheel matches the mark on the cover (H). The hand
wheel will click and is locked in threading position.
Turn the looper selection lever to the left (I) to activate
the upper looper threading.
Using the tweezers, insert the end of the thread 2 cm or
more into the upper looper threading hole (J).
Note:
• Trim the thread end so that it can be inserted into the
threading hole smoothly.
• If threading special threads, such as wooly nylon, etc.,
refer to pages 18-19.
Raise the looper threader lever (K) until it clicks into
place. Lower it again until it knocks into place.
Make sure that the thread comes out from the hole of the
upper looper tip (L).
If the thread does not come out from the hole, follow the
procedure from step J/K again.
Set the Threading/Sewing switch (G) to “Sewing” posi-
tion (M).
Pull 4˝ (10 cm) of the thread under the toe of the foot, and
back between the presser fot foot and the upper cutter (N).
Close the front cover and lower the presser foot lifter.
Loading ...
Loading ...
Loading ...