Loading ...
Loading ...
Loading ...
23
Option C: Waste disposer – with air gap
A
B
C
D
E
F
G
A. Screw-type clamps
B. Disposer inlet
C. Drain trap
D. Drain hose
E. Rubber hose connector
F. Large drain hose clamp
G. Air gap
Helpful Tip: Remove disposer knockout plug.
1
1. Using a hammer and screwdriver,
knock plug into disposer.
2
2. Use needle-nose pliers to remove plug.
A
3
3. Connect rubber end (A) of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
4
4. Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
1
/
2
" to 2" (38 mm to 50 mm) screw-
type clamp (not provided).
5
5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
Option D: No waste disposer – with air gap
B
A
C
D
E
F
G
A. Screw-type clamps
B. Waste tee
C. Drain trap
D. Drain hose
E. Rubber hose connector
F. Large drain hose clamp
G. Air gap
A
1
1. Connect rubber end (A) of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
2
2. Attach drain hose to air gap with large
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
1
/
2
" to 2" (38 mm to 50 mm) screw-
type clamp (not provided).
3
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
Loading ...
Loading ...
Loading ...