Loading ...
Loading ...
Loading ...
13
15. Slide nut and ferrule onto tubing (copper
tubing only)
A
B
A. Nut
B. Ferrule
Copper tubing only: Put the tubing into the 90° elbow fitting
as far as it will go. (The copper tubing bends and kinks
easily.) Slide the nut and ferrule forward and start the nut
onto the elbow threads.
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base,
frame, or motor. Go to step 18.
16. Flexible line
Flexible braided line: Confirm the flexible braided line is
long enough.
17. Add 90° elbow fitting to the water supply line
Get 3/8" (9.5 mm) compression x 3/4" (19 mm) hose fitting
with 90° elbow. See the “Tools and Parts” section at the front
of the guide for part details and order. Connect the 3/8"
(9.5 mm) compression fitting of the 90° elbow fitting to the
water supply line. Attach so the 3/4" (19 mm) connection is
facing upward as shown above.
Connect Fill Hose to Fill Valve
18. Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide the
3/4" (19 mm) fitting of the 90° elbow up to the valve and
hand-tighten to avoid cross-threading. Hand-tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 1/4 to 1/2 turn may be required to
seal the rubber gasket. Route fill hose out the rear left side of
unit.
NOTES:
n Do not use PTFE plumber's tape with compression
fittings.
n Do not overtighten. Damage to the coupling can result.
Drain Hose Connection
19. Connect drain hose
A
B
C
D
E
A. Small clamp
B. Rubber drain
hose connector
C. Stop
D. Drain hose stop
E. Drain hose
Place towel under drain hose to catch any water in drain
hose. Place the small (green) drain hose clamp onto the
small end of the drain hose. Push the new drain hose into the
rubber drain hose connector up to the drain hose stop.
Loading ...
Loading ...
Loading ...