Loading ...
Loading ...
Loading ...
REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and increase your satisfaction with
your Kenmore dryer.
[] Check that all parts you removed
from the parts packages are now
installed.
[] Ensure that dryer is positioned in its
final location. Make sure vent is not
crushed or kinked.
[] Ensure that dryer is level by placing
a level on top of the dryer. Check
side-to-side first, then check front-to-
back. If dryer is not level, adjust the
legs up or down.
[] Check to make sure you have all
the tools you started with.
FINAL STEPS
[] Plug the power supply cord into
the grounded outlet or power supply.
[] Turn power supply on.
[] Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining
on dryer.
[] Take a few minutes and read the
Operating Instructions (pgs. 23-29)
to fully understand your new dryer.
[] To remove air from the gas line, set
the dryer on a full heat cycle (not the
AIR DRY Cycle) for 20 minutes. After
five minutes, open dryer door. The
burner should have ignited during
these five minutes. If you do not feel
heat, turn the dryer off and WAIT
5 MINUTES. During these 5 minutes
check to be sure dryer gas supply
valve is open. Repeat steps above.
If the burner still does not ignite,
see "TROUBLESHOOTING" on
pages 36-37.
22
Loading ...
Loading ...
Loading ...