Loading ...
Loading ...
Loading ...
Mulching Operation
For best mulching results, cut up to a maximum of 1/3
of grass length and mulch ONLY when grass is dry.
1. Make sure the discharge deflector and grass bag
are removed, and the mulching plug is installed.
2. Set the cutting height adjust to the highest cutting
position.
3. Proceed mowing slowly. Gradually lower the cut-
ting height to obtain the best combination of cut-
ting and mulching performance. Cutting too much
grass in one pass, or cutting wet heavy grass may
cause clumping or plugging of the mower deck.
Installing the Discharge
Installing the Grass Bag
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components are
ROT. Avoid serious burns, allow sufficient time for all com-
ponents to cool.
important: The mulching plug must be removed only
when bagging is desired, and must be replaced as
soon as bagging operations are completed.
1. Raise the rear discharge door (A, Figure 10).
2. Remove the mulching plug (B) from the rear dis-
charge chute.
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark ptug. Engine and components are
ROT. Avoid serious burns, allow sufficient time for all com-
ponents to cool.
1. Raise the mulching cover (A, Figure 9}.
2. Install the deflector (B} to the deck under the
mulching cover, making sure that the locking tabs
on the deck (C} go through the slots in the deflec-
tor (B).
3. Lower the mulching cover against the deflector .........
Figure 10: Remow'ng the mulching plug
3. Holding the grass bag handle (A, Figure 11),
install the grass bag onto the mower, making sure
that the grass bag hooks (B) are hooked onto the
rear door pivot rod (C).
Figure 9: Instafling the discharge deflector
14 www.anapper.eom
Loading ...
Loading ...
Loading ...