Loading ...
Loading ...
Loading ...
13
FINAL INSTALLATION
4. Install the blade arm (R) to the underside of the
motor assembly (H) with motor screws (J) previously
removed (Step 6, page 8). Tighten with Phillips
screwdriver. Repeat for each blade arm (R).
5. Remove one and loosen the other two tter plate
screws (L) but do not remove from tter plate (K).
Feed the 9-pin connector through center hole in light
pan. Align the two keyhole slots in the light pan (M)
with the loosened tter plate screws (L). Place the
light pan (M) over the two screws and turn the light
pan (M) clockwise. Then tighten the two tter plate
screws (L). Re-install the tter plate screw (L) that
was removed in the previous step and tighten rmly.
6. Remove one and loosen the other two light pan
screws (N) from the underside of the light pan (M).
Connect the 9-pin connector from the tter plate (K)
to the 9-pin connector from the light kit (O). Align the
keyhole slots in the light kit (O) with the loosened
screws in the light pan (M). Turn light kit (O) clockwise
and replace the previously removed light pan screw
(N). Tighten all screws.
4
H
O
N
L
M
K
R
J
5
6
9-pin
Connector
Keyhole
Slot
Keyhole
Slot
Loading ...
Loading ...
Loading ...