Loading ...
Loading ...
Loading ...
Page 7www.123filter.com
| (678) 261
A.
Source water from Feed Water Adapter
C.
Waste water from Flow Restrictor
E.
RO water from stage 5 “T” fitting
F.
When the drinking faucet is opened, RO water from the tank pass
water to the drinking faucet
*Note, the diagram
represents a faucet with non
the pure water line, and the flow restrictor doubles as
entering back into the system.
Before you begin the installation, it is highly recommended that you watch the
video
“iSpring Reverse Osmosis Installation”
Note:
If you plan on mounting/hanging the system, it is high
include supports under each of the bottom three housings. Supports under the
housings will take the water weight off the housing threads, and ensure the thread strength does not
decay over the years.
| (678) 261
-7611 | Support@123Filter.com
Sample Installation
Figure 5
Source water from Feed Water Adapter
→ B.
Source water to 1st stage water inlet
Waste water from Flow Restrictor
→D. Waste water to Drain Saddle/drain pipe
RO water from stage 5 “T” fitting
→ F. RO water to Storage Tank
When the drinking faucet is opened, RO water from the tank pass
es through E and G
represents a faucet with non
-
air gap installation. There is a one valve present on
the pure water line, and the flow restrictor doubles as
a one-way
valve preventing drain water f
Installation Steps
Before you begin the installation, it is highly recommended that you watch the
“iSpring Reverse Osmosis Installation”
on YouTube.
If you plan on mounting/hanging the system, it is high
ly recommended to
include supports under each of the bottom three housings. Supports under the
housings will take the water weight off the housing threads, and ensure the thread strength does not
Flow
Restrictor
Source water to 1st stage water inlet
es through E and G
→ H. RO
air gap installation. There is a one valve present on
valve preventing drain water f
rom
Before you begin the installation, it is highly recommended that you watch the
ly recommended to
include supports under each of the bottom three housings. Supports under the
housings will take the water weight off the housing threads, and ensure the thread strength does not
Loading ...
Loading ...
Loading ...