Loading ...
Loading ...
Loading ...
49-2000742 Rev. 0 11
INSTALLATION
MOUNT RANGE HOOD TO THE WALL
1. Determine and mark the centerline on the wall
where the canopy hood will be installed.
2. Select a mounting height between a minimum of
24” (61.0 cm) for an electric cooking surface, a
minimum of 27” (68.6 cm) for a gas cooking surface,
and a suggested maximum of 36” (91.4 cm)
above the range to the bottom of the hood. Mark a
reference line on the wall.
3. Place the vent hood on the wall, adjust to align and
fasten with screws and screw anchors suited to the
wall type (reinforced concrete, plasterboard etc.)
4. Mark centers of the fastener locations through the
template to the wall.
IMPORTANT: All screws must be installed into
wood. If there is no wood to screw into, additional
wall framing supports may be required.
Remove the template.
5. Drill 3/16" (4.8 mm) pilot holes at all locations where
screws are being installed into wood.
6. Install the 2 - 5 x 45 mm mounting screws. Leave a
1/4" (6.4 mm) gap between the wall and the back of
the screw head to slide range hood into place.
VENT COVER BRACKET
INSTALLATION
1. Attach vent cover bracket to wall flush to the ceiling
using 2 - 5 x 45 mm screws.
COMPLETE PREPARATION
1. Determine and make all necessary cuts in the wall
for the vent system. Install the vent system before
installing the hood. See “Venting Requirements”
section.
2. Determine the required height for the home power
supply cable and drill a 1-1/4” (3.2 cm) hole at this
location.
3. Run the home power supply cable according to the
National Electrical Code or CSA Standards and
local codes and ordinances. There must be enough
1/2” conduit and wires from the fused disconnect (or
circuit breaker) box to make the connection in the
hood’s electrical terminal box.
NOTE: Do not reconnect power until installation is
complete.
4. Use caulk to seal all openings.
INSTALL RANGE HOOD
1. Using 2 or more people, hang range hood on 2
mounting screws through the mounting slots on
back of hood.
2. Remove the grease filter. See Care and Cleaning
section.
3. Level the range hood and tighten upper mounting
screws.
4. Install 2 - 5 x 45 mm lower mounting screws and
tighten.
Installation
1/4"
(6.4 mm)
a
b
c
Loading ...
Loading ...
Loading ...