Loading ...
Loading ...
Loading ...
• 9 •
5.6 USING THE INFLATOR
WARNING: RISK OF EXPLOSION.
Read instructions of the product being inated before using the inator. Avoid overination, do not
exceed the manufacturer’s recommended pressures. Do not leave the inator unattended during use.
1. Ensure the battery clips are securely on the storage holders.
2. Attach the corrugated hose with end adapter to the high-ow inator outlet located near the
Compressor/Inator switch on the back of the unit.
3. The main accessory adapter attached to the corrugated hose accommodates up to 4 sizes. If another
size is needed, an additional adapter can be attached to the end of the main accessory adapter.
4. Insert the adapter into the product to be inated.
5. Push the Compressor/Inator switch to the INFLATOR position and inate the product.
6. When the product is inated to the desired level, push the Compressor/Inator switch to the OFF
position and remove the adapter.
Estimated time for inating
Vehicle tires 13-16" 6-24 minutes
Bike tires 1-3 minutes
Sports balls 30 seconds
These times are approximate. Use the air compressor gauge
to ensure the proper pressure has been reached. Do not overinate.
5.7 USING THE DEFLATOR
1. Ensure the battery clips are securely on the storage holders.
2. Attach the corrugated hose with the end adapter to the high-ow deator outlet, which is located on the
side of the unit.
3. The main accessory adapter attached to the corrugated hose accommodates up to 4 sizes. If another
size is needed, an additional adapter can be attached to the end of the main accessory adapter.
4. Insert the adapter into the item to be deated.
5. Push the Compressor/Inator switch to the INFLATOR position and deate the item.
6. When the product is deated to the desired level, push the Compressor/Inator switch to the OFF
position and remove the adapter.
5.8 BEFORE USING THE CONVERTER
Important Safety Instructions:
1. Keep the unit well ventilated, in order to properly disperse heat generated while it is in use.
Make sure there are several inches of clearance around the top and sides, and do not block the vents
on the back of the unit.
2. Make sure the unit is not close to any potential source of ammable fumes or clothing.
3. Keep the unit dry.
4. DO NOT allow the unit to come into contact with rain or moisture.
5. DO NOT operate the unit if you, the unit, the device being operated or any other surfaces that may
come in contact with any power source are wet. Water and many other liquids can conduct electricity,
which may lead to serious injury or death.
6. Do not place the unit on or near heating vents, radiators or other sources of heat.
7. Do not place the unit in direct sunlight. The ideal air temperature for operation is between 50° and 80° F.
8. Do not use the converter near an open engine compartment where fumes may accumulate.
9. Do not modify the AC receptacles in any way.
Loading ...
Loading ...
Loading ...