Loading ...
Loading ...
Loading ...
• 11 •
6. MAINTENANCE INSTRUCTIONS
6.1 After use and before performing maintenance, unplug and disconnect the jump starter.
6.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips, cords and the
jump starter case.
6.3 Ensure that all of the jump starter components are in place and in good working condition.
6.4 All servicing should be performed by qualied service personnel.
7. MOVING AND STORAGE INSTRUCTIONS
7.1 Store inside, in a cool, dry place.
7.2 Do not store the clips on the handle, clipped together, on or around metal, or clipped to cables. The clips
on the jump starter are live when the switch is in the ON position and will produce arcing or sparking if
they come in contact with each other. To prevent accidental arcing, always place the switch in the OFF
position and keep the clips on the storage holders when not using it to jump start a vehicle.
7.3 If the jump starter is moved around the shop or transported to another location, take care to avoid/
prevent damage to the cords, clips and jump starter. Failure to do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the jump starter in or on any area or surface where damage
could occur if the internal battery should unexpectedly leak acid.
7.4 IMPORTANT:
• CHARGE IMMEDIATELY AFTER PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter’s internal battery immediately after purchase, after every use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is at 70°F. The internal battery will
gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a
discharged state may result in permanent battery damage. To ensure satisfactory performance and avoid
permanent damage, charge the internal battery every month.
8. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The unit won’t jump start my car. Jump Start/USB switch is not
turned ON.
Clips are not making a good
connection to the battery.
The internal battery is not charged.
The vehicle’s battery is defective.
Turn ON the Jump Start/USB Switch.
Check for poor connection to battery
and frame. Make sure connection
points are clean. Rock clamps back
and forth for a better connection.
Check the battery charge status by
pressing the button on the front of the
unit. See Checking the Level of the
Internal Battery.
Have the battery checked.
The unit won’t power my 12V
device.
The 12V device is not turned on.
The internal battery is not
charged.
The 12V device draws more than
20A, has a short circuit, or the
internal fuse has blown.
Turn on the 12V device.
Check the battery charge status by
pressing the button on the front of the
unit. See Checking the Level of the
Internal Battery.
Disconnect the 12V device.The
internal 20A fuse needs replacement
by a qualied service person.
The battery in the unit won’t
hold a charge.
The battery is bad (will not accept
a charge).
Have the battery checked.
Loading ...
Loading ...
Loading ...