Loading ...
Loading ...
Loading ...
• 8 •
NOTE: When connected to the vehicle, the display shows the vehicle’s battery voltage. When connected
and in the ON position, the display shows the equalized voltage between the vehicle’s battery and
internal battery.
6. Crank the engine for no more than 8 seconds. If the engine does not start, wait 2 minutes before
cranking again.
7. After the engine starts, turn the switch to the OFF position and remove the jump starter from the battery.
8. Charge the unit.
5.2 USING THE USB PORT
The USB port provides up to 2A at 5V DC.
1. Ensure the battery clamps are securely clipped on the storage holders.
2. Turn the unit ON.
3. Plug your device into the USB port.
4. When nished using the USB port, turn the switch to the OFF position.
5. Charge the unit.
5.3 USING THE WORK LIGHT
The work light is controlled by a sliding ON/OFF switch located on the front of the unit.
• Make sure the lamp is turned OFF when the unit is being recharged or stored.
• Position the unit on a at, stable surface near the intended work area.
• Ensure the battery clamps are securely clipped on the storage holders.
5.4 POWERING A 12V DC DEVICE
The unit is a power source for all 12V DC accessories that are equipped with a 12V accessory plug. Use
it for power outages and on shing or camping trips.
NOTE: Do not power a 12V device with the unit while charging the internal battery.
1. Make sure the device to be powered is OFF before inserting the 12V DC accessory plug into the 12V
DC accessory outlet.
2. Open the protective cover of the DC power outlet on the unit.
3. Plug the 12V DC device into the DC power outlet and turn on the 12V DC device (if required).
4. When nished, turn off the DC device (if required) and unplug from the DC power outlet.
CAUTION: Do not use the unit to run appliances that draw more than 20A DC.
NOTE: Extended operation of a 12V DC device may result in excessive battery drain. Recharge the unit
immediately after unplugging the 12V DC device.
5.5 USING THE AIR COMPRESSOR
NOTE: To prevent overheating, the compressor has built-in thermal protection that will turn the
compressor off before it overheats. If the compressor shuts off, wait a few minutes and it will
automatically restart when the compressor cools.
WARNING. Read the instructions of the product being inated before using the compressor. Avoid
overination; do not exceed the manufacturer’s recommended pressures. Do not leave the air
compressor unattended during use.
1. Remove the air compressor hose from the storage compartment.
2. Connect the adapter to the valve stem by threading it onto the end. If necessary, use one of the
additional adaptors.
3. Turn ON the inator power switch and inate to the desired pressure or fullness.
4. When the desired pressure is reached, put the inator power switch to OFF, open the thumb latch and
remove the connector from the valve stem.
5. Allow unit to cool.
6. Recharge the unit before storing.
NOTE: The air compressor is rated for 150 PSI.
Loading ...
Loading ...
Loading ...