Kenmore 11071082000 dryer

User Manual - Page 5

For 11071082000.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
5
INSTALLATION
INSTRUCTIONS
Tools and parts
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Parts supplied
Remove parts package from dryer drum. Check that all parts
were included.
4 leveling legs
Parts needed:
Check local codes and with gas supplier, check existing gas
supply, electrical supply and venting, and read “Electrical
Requirements”, “Gas Supply Requirements” and “Venting
Requirements” before purchasing parts.
Location Requirements
You will need
A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See “Venting
Requirements.”
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See “Electrical Requirements.”
A sturdy floor to support the dryer with a total weight (dryer
and load) of 175 lbs (79 kgs).
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (If slope is greater than 1 in. (2.5 cm), install
Extended Dryer Feet kit, Part No. 279810.) Clothes may not
tumble properly and automatic sensor cycles may not
operate correctly if dryer is not level.
Do not operate or store your dryer in a location with year-round
temperatures below 45ºF (7ºC). At lower temperatures, the dryer
might not shut off at the end of an automatic cycle. Drying times
can be extended.
Install the dryer where it is protected from water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE:
No other fuel-burning appliance can be installed in the
same closet as a dryer.
WARNING:
To reduce the risk of fire, this appliance MUST
BE EXHAUSTED OUTDOORS.
8” or 10” pipe wrench
8” or 10” adjustable
wrench (for gas
connections)
flat-blade screwdriver
adjustable wrench that
opens to 1 in. or hexhead
socket wrench (for
adjusting dryer feet)
level
¹⁄₄
in. nut driver or socket
wrench
knife
safety glasses
duct tape
pipe-joint compound
resistant to L.P. gas
caulking gun and
compound (for installing
new exhaust vent)
gloves
pliers
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Loading ...
Loading ...
Loading ...