Craftsman 351229000 drill press

User Manual - Page 13

For 351229000.

PDF File Manual, 60 pages, Download pdf file

Loading ...
Loading ...
Loading ...
TOOLS REQUIRED
The following tools are needed for assembly and align-
ment. Note: Hex wrenches are provided. The remaining
tools are typical shop tools and are not included with
your drill press.
17mm Open end wrench Straight screwdriver
Hammer and block of wood Combination square
The drill press is a heaw machine; two people may
be required for certain assembly operations.
DO NOT assemble the drill press until you are sure
the tool is unplugged.
DO NOT assemble the drill press until you are sure
the power switch is in the "OFF" position.
For your own safety, DO NOT connect the drill press
to the power source until the machine is completely
assembled and you read and understand the entire
Instruction Manual.
COLUMN, BASE AND TABLE ASSEMBLY
Figure 4-1
B
.
C
Attach the column (A) to the base (B) using the four
MIO x 40mm hex head screws (C), two of which
are shown. See Figure 4-1.
Figure 4-2
F
D
.
Attach the table raising and lowering handle (D) on
the worm gear shaft (E). Make sure to position the
set screw (F) over the flat (G) on the worm gear
shaft and tighten the set screw. See Figure 4-2.
Figure 4-3
J
K
/
J
.
Assemble the threaded end (H) of the table height
lock handle (I) into hole (J) in the rear, left side of
the table support (K). Note: The table height lock
handle is the larger of the two lock handles. See
Figure 4-3.
13
Loading ...
Loading ...
Loading ...