Loading ...
Loading ...
Loading ...
6
COOKTOP USE
Electric igniters automatically light the surface burners
when control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on
the grate. Do not operate a burner using empty cookware
or without cookware on the grate.
The flame should be adjusted so it does not extend beyond the
edge of the pan.
NOTE: Visually check that the burner has lit. If the burner does
not ignite, listen for a clicking sound. If you do not hear the igniter
click, turn the burner off. Check for a tripped circuit breaker or
blown household fuse.
Check that the control knob is pressed completely down on the
valve shaft. If the spark igniter still does not operate, call a trained
repair specialist.
To Set:
1. Push in and turn knob counterclockwise to IGNITE.
All surface burners will click. Only the burner with the
control knob turned to IGNITE will produce a flame.
2. Turn knob to anywhere between Hi and Lo.
Power Failure
In case of a prolonged power failure, the surface burners cannot
be lit manually. No attempt should be made to operate the
appliance during a power failure.
Sealed Surface Burners
IMPORTANT: Do not obstruct the flow of combustion
and ventilation air around the burner grate edges.
Burner Cap: Always keep the burner cap in place when using
a surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover,
and routinely remove and clean the caps according to the
“General Cleaning” section.
Gas Tube Opening: Gas must flow freely throughout the gas
tube opening for the burner to light properly. Keep this area free
of soil and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube opening by always using a burner cap.
Burner Ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF
and the cooktop is cool. Do not use oven cleaners, bleach, or
rust removers.
1. Remove the burner cap and the burner base and clean
according to the “General Cleaning” section.
2. Clean the gas tube opening with a damp cloth.
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
A
B
D
E
C
C
D
A
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter
E. Gas tube opening
B
A
A. 1" to 1
1
/
2
" (2.5 cm to 3.8 cm)
B. Burner ports
Loading ...
Loading ...
Loading ...