Loading ...
Loading ...
Loading ...
28
INSTALLATION
Check the appliance is electrically safe when you have nished.
ArtNo.010-0004 Moving the cooker
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
oven doors so that you can get a good grip on the bottom of
the fascia panel as you move the oven (Fig. 10.11).
Carefully push the range backwards o the base tray. Remove
the base tray.
Position the range close to its nal position, leaving just
enough space to get behind it (Fig. 10.12).
Do not use the door handles or control knobs to
manoeuvre the range.
Levelling the Range
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the range in its intended position. Take care not to twist
it within the gap between the kitchen units as damage may
occur to the range or units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the range use a
13 mm spanner or socket wrench to turn the hexagonal
adjusting nuts at the front bottom corners of the range.
To set the front turn the feet bases to raise or lower.
Fitting the stability bracket
We recommend using a stability bracket; rst attach the
bracket location device to the rear of the range (Fig. 10.13).
Then adjust the bracket to engage through the slot of the
device (Fig. 10.14 and Fig. 10.15).
Repositioning the Range Following
Connection
If you need to move the range once it has been connected,
make sure it is switched o at the supply switch before
gripping under the fascia panel and lifting the front of the
range slightly (Fig. 10.11). Check behind the range to make
sure that the electricity cable is not caught.
As you progress, always make sure that the cable has
sucient slack to allow the range to move.
When you replace the range, check behind it again once
more to make sure that the electricity cable is not caught or
trapped.
Fig. 10.11
Fig. 10.12
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical oor mounting
Alternative positions
for stability location
bracket
Fig. 10.13
Fig. 10.14
Fig. 10.15
Loading ...
Loading ...
Loading ...