Loading ...
Loading ...
Loading ...
MOUNTING SAW
1. From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16 in. - 18 x 1-1/4 in. long.
4 Hex Nuts, 5/16 in, - 18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx. dia. of
hole, 5/16 in,)
8 Flat Washers, (dia. of hole 11/32 in.)
2. Place saw on legsso that holes in bottom of saw line up
with holes in top of legs.
3. nstall screws,washersand nuts asshown.
SAW BASE
HEX HEAD SCREW
-,..,
/
/
FLAT
END
STIFFENER-"_j
FLAT WASHE
HEX
If you mount the saw on any other bench, make sure that
there is an opening in the top of the bench the same size as
the opening in the bottom of the saw so that the sawdust
can drop through. Recommended working height is 33 to
37 inches from the top of the saw table to the floor.
13
2-3/4
_I-V4
7/16 DIA. HOLES
/
OPENING
16 13
/ \\ ®
// \ \ ,.,,-
FRONTOF SAW I/2
NOTE: All dimensions in inches
ATTACHING TABLE EXTENSIONS
If you received Table Extensions with your saw (two
furnished with Model No. 113.299040 or one furnished
with Model No. 113.298470) attach them at this time.
If you have only one Table Extension, it may be attached
to either side.
NOTE: When the Table Extension is attached to the left
side, it offers more support to the workpiece, especially
when crosscutting or mitering long boards. When attached
to the right side, it offers more support when cutting wide
panels.
If you attach the Extension to the left side, be sure to
construct the Auxiliary Fence/Work Support and Push
Block shown on page
1. From among the loose parts find the following
hardware;
8 Hex Head Screws 5/16 in. - 18 x 1-1/4 in. long
8 Lockwashers, 5/16 in. External Type (approx. dia. of
hole 5/16 in.)
8 Hex Nuts, 5/16 in. - 18 (approx. dia. of hole 5/16 in.)
Insert screws through holes in EXTENSION then through
table. Install Iockwashers and screw on the nuts ... DO
NOT TIGHTEN.
BLOCK OF WOOC
\
/
I
Align front edge of extension with front edge of saw table.
Pull Extension UPWARDS above table surface ..
SLIGHTLY TIGHTEN SCREWS using I/2 in. wrench.
Using small block of hardwood and hammer, tap extension
DOWNWARDS at front, center & rear, until it is EVEN
with table surface ... TIGHTEN SCREWS,
Loading ...
Loading ...
Loading ...