Loading ...
Loading ...
Loading ...
\
\
CZ>
/
3.
4.
Insert forefinger into table-insert slot and pull upward
to remove insert.
Replace nsert. If clips do not hold insert securely,
remove insert end bend clips.
SPRING CLIP
/ -.
-- I /
_ (
\" t "_ BEND CLIPS
k,.__" AS NEEDED
t.._ SPRING CLIP
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT: BLADE must be SQUARE (g0°) to
TABLE, in order to proceed with assembly.
1. Turn ELEVATION crank clockwise until blade is up as
high asit will go.
2. Check for BLADE SQUARENESS ... if blade is not
square to table, adjust it at this time.
NOTE: The combination square must be "true" - see
start of "Unpacking and Checking Contents" Section on
page6 for checking method.
Refer to "BLADE TILT, OR SQUARENESS OF BLADE
TO TABLE" adjustments on page 30.
MAKE SURE SQUARE
IS NOT [OUCHING
TIP OF TOOTH
ASSEMBLING STEEL LEGS
NOT SUPPLIED IN CANADA
NOTE: Steel Legs ere furnished with Model 113.299040
and 113.298470. From among the loose parts, find the
following Hardware:
24 Truss Head Screws, 1/4 in. - 20 x 5/8in. long (top of
screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia. of
hole 1/4 in.)
24 Hex Nuts, 1/4 in. - 20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts. 1/2 in. - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feel
Assemble the legs as shown ...
1. Insert the Truss Head Screws through the holes in the
legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES N
THE SIDE STIFFENERS MARKED "'X".
2. Install the Iockwashers ... screw on the nuts but do
not tighten until completely assembled.
3. Install leveling feet.
END
STIFFENER"
SIDE STIFFENER
IN. HEX NUTS
__._..----- LEVELING FOOT
8
Loading ...
Loading ...
Loading ...