Loading ...
Loading ...
Loading ...
Problem Possible cause(s) Solution(s)
Water is leaking out. Dryer is not leveled. Level the dryer.
---> Leveling the dryer; Page 15
The heat exchanger seal is dirty. Clean the heat exchanger seal.
---> Cleaning the heat exchanger; Page 27
Drain hose is leaking. Check entire length of drain hose for leaks; replace if
necessary.
Check that hose is clamped on hose barb at back of
the dryer securely.
Program terminates Laundry is not loaded. Load the laundry.
shortly after starting. ---> Loading the laundry; Page 21
Load too small for selected pro- Use time program.
gram. ---> Program selection table; Page 24
Loaded laundry is too dry. Check the loaded laundry. If it is dry, open the door,
remove laundry and turn program selector to Off.
The door opens by The door not closed properly. Close the door until a click is heard.
itself.
Creasing. Laundry load exceeded. Do not exceed the maximum load for selected pro-
Unsuitable program selected, gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to Off.
---> Program selection table; Page 24
Drying result is not sat- Warm laundry may feel more damp Remove items of laundry immediately after the end of
isfactory (laundry feels than it really is. the program and turn the program selector to Off.
too damp). The selected program does not suit Use another drying program or, in addition, select the
the load. time program.
---> Program selection table; Page 24
Dryness level is not adjusted. Use Dry Level to adjust the dryness level.
--> Dry Level; Page 25
Fine layer of limescale on the mois- Clean the moisture sensors.
ture sensors. ---> Cleaning the moisture sensors; Page 28
Program termination e.g. main See the problem(s) mentioned in this table.
power supply failure, door open or
maximum drying time reached.
Initial load is too wet. Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and than turn it on again.
Drying time too long. Lint filter and/or Heat Exchanger is Clean lint filter
dirty. ---> Cleaning the lint filter; Page 26
and/or Heat Exchanger.
---> Cleaning the heat exchanger; Page 27
Insufficient supply of air. Ensure that air can circulate.
Air inlet possibly blocked. Do not obstruct the air inlet on the front of the dryer.
Ambient temperature higher than Ventilate the room.
95°F/35°C.
Program does not start A delayed starting time has been Drying cycle will begin at proper time to complete at
Finish in (remaining) selected and activated, the selected Finish in time.
time is displayed.
Program does not start Childproof look is activated. Deactivate Childproof look.
- o= symbol lit up. ---> Childproof lock; Page 22
30
Loading ...
Loading ...
Loading ...