Loading ...
Loading ...
Loading ...
ENGLISH
OPERATING PROCEDURE
Initializing the System for the first time
Install the 4 AA batteries into the receiver battery bay. Note the polarity of the battery and
insert into the battery bay as indicated on the Battery cover (+/-). Place the 3 position slider
switch in the “Remote” position. (fig. 3) Using the end of a paper clip, or other similar object,
insert the end of the paper clip into the hole marked “PRG” on the Receiver front cover (fig 3).
The Receiver will “beep” three (3) times to indicate that it is ready to synchronize with a
Transmitter. Install the 3 AAA type batteries in the Transmitter battery bay, located on the
base of the Transmitter. With the batteries already installed in the Transmitter, push the On
button. The Receiver will “beep” four times to indicate the Transmitter’s command is accepted
and sets to the particular code of that Transmitter. The system is now initialized.
Fig. 7: Remote Control display.
Temperature indication Display
With the system in the “OFF” position, press the Thermostat Key and the Mode Key at the same
time. Look at the
LCD screen on the
Transmitter to verify
that a C or F is visible
to the right of the
Room Temperature
display. (Fig. 6)
Fig. 6: Remote Control display in Farenheit and Celsius.
Turn on the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter display will show all active Icons on the
screen. At the same time the Receiver connects the thermopile to the gas valve millivolt coil and
the appliance main burner turns on. A single “beep” from the Receiver will confirm reception of
the command.
Turn off the Appliance
Press the ON/OFF Key on the Transmitter. The Transmitter LCD display will only show the room
temperature and Icon (Fig. 7). At the same time the Receiver disconnects the thermopile from
the gas valve millivolt coil and the appliance burner turns off. A single “beep” from the Receiver
confirms reception of the command.
7
Loading ...
Loading ...
Loading ...