Loading ...
Loading ...
Loading ...
6
CAD-BND in Reverse Orientation:
The Bend Units can also be mounted in the reverse orientation so that
the front face of the CAD carts or refrigerators face away from one
another.
Position the CAD cart (or refrigerator) in the intended position.1.
Place the three cardboard lifters from the packaging on the 2.
ground next to the cart (or refrigerator) in the approximate
position of the Bend Unit (Fig. 18).
Place the Bend Unit on top of the lifters, adjacent to the CAD cart. 3.
To ensure proper alignment, make sure the front of the cart is
ush with the wall or door of the Bend Unit (Fig. 19).
Remove the door from the Bend Unit by removing the screw 4.
holding the rear riser bracket near the door hinge (Fig. 20). This
must be done to provide access to the mounting holes.
Secure the two together using (2) hex bolts (1/4-20 x 1/2”), (4) 5.
washers (5/16 x 3/4), and (2) hex nuts (1/4-20) through the top/
front set of holes in the Bend Unit and middle holes in the cart
(Fig. 21). (If mounting to fridge, use the bottom/front set of holes
in the Bend Unit and bottom holes in fridge [Fig. 22].)
Position second cart (or fridge) on the other side of the Bend Unit 6.
and secure to Bend Unit as in Step 5.
When Bend Unit is secured to the two supporting structures 7.
(refrigerator or cart), re-install the door, remove the cardboard
lifters and place the solid surface on top.
Once complete the units should look like Fig. 23. 8.
Fig. 18
Fig. 19
Fig. 20
Fig. 23
Cardboard
lifters in
intended
location of
Bend Unit
Rear riser bracket
FRONT
REAR
SIDE VIEW
FRONT
REAR
FRONT
REAR
SIDE VIEW
FRONT
REAR
Fig. 21
Fig. 22
BEND UNIT
REFRIGERATOR
Use shaded holes
Use shaded holes
BEND UNIT CAD CART
Use shaded holes
Use shaded holes
Front
Rear
Loading ...
Loading ...