Loading ...
Loading ...
Loading ...
23
W415-1678 / 08.09.16
EN
3.11 REAR EXIT
!
WARNING
FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
A. Remove the safety screen and glass front, refer to " SAFETY SCREEN / DOOR REMOVAL AND
INSTALLATION" section.
B. Remove the contents from the fi rebox and set aside, you will need the exhaust and air inlet collar.
C. To ease assembly, remove the four hex head screws securing the defl ector from inside the top front of
the fi rebox, refer to Figure 1.
D. Place the gasket (provided) over the 4" (102mm) fl ue
collar assembly and bend along perforation.
E. From inside the fi rebox, insert the 4" (102mm) fl ue collar
through the back of the fi rebox. Install the rear exit shield
onto the 4" (102mm) fl ue collar, see "REAR EXIT SHIELD"
section for installation instructions.
F. Secure the fl ue collar assembly, gasket and rear exit shield using the four
black pan head 5/8" thread cutting screws, refer to Figure 2. NOTE: Do not
overtighten. The gasket needs only to be snug against the fi rebox.
G. Reattach the defl ector using the four screws and install the log set, glass
door and safety screen.
H. Install the 7" collar assembly, complete with gasket onto the rear panel
around the 4" (102mm) collar with the screws provided, refer to Figure 3.
Fig. 2
DEFLECTOR
É
Fig. 1
3.12 REAR EXIT SHIELD (FOR REAR VENT ONLY)
A. Remove the safety barrier assembly and
door from the appliance, refer to the
“SAFETY SCREEN & DOOR REMOVAL
/ INSTALLATION” section of the manual
for detailed instructions.
B. Loosen the two screws, that secure
the exhaust plate, and slide the shield
in place by sliding its slotted openings
behind the screwheads, tighten the two
previously loosened screws. Refer to
the illustration.
C. Reinstall the door and safety barrier
assembly on the appliance, refer to the
“SAFETY SCREEN & DOOR REMOVAL
/ INSTALLATION” section of the manual
for detailed instructions.
NOTE: THIS SHIELD IS USED TO BLOCK THE VIEW THROUGH THE VENTING TO THE OUTDOORS.
Fig. 3
INTAKE COLLAR
ASSEMBLY
GASKET
Loading ...
Loading ...
Loading ...