Loading ...
Loading ...
Loading ...
AUTOMATIC POWER CORD RECOIL SYSTEM
(FIG. Q)
1. To extend the power cord, release by lifting up on
the locking lever, then pull the power cord to the
desired length and then lock lever in position.
2. To return the cord to storage, release the locking
lever, softly pull the power cord out to retract the
cord fully, then lock the lever.
ADJUSTING THE REAR TABLE EXTENSION
1. The rear table extension should be positioned as
close as possible to the rear of the table when
ripping short work pieces.
2. The rear table extension should be pulled out fully
when ripping long work pieces that require extra
support.
ADJUSTING CAM LOCKING LEVER (FIG. Q-l)
If the extension table moves when it is open and
locked, then the cam locking lever (1) may be loose
and need adjustment, therefore, adjustment to the cam
locking lever is necessary. To adjust the locking lever
tension, turn the bar (2) with a 10mm wrench until it is
tightened, but do not over tighten.
1
Fig. Q -1
2
__ /
J
JJi
Folding the table
1. Release the latches on the narrower (shorter) leg
set (1). Hold the table and lift the saw up just
above the ground and fold up the narrower
(shorter) leg set. Note: The narrow leg set is held
with a "spring-clip'.
2. Then reposition the saw onto the ground. Release
the latches (2) on the wider leg set then fold the
other leg set up into position.
3. Then fasten the legs with stand buckle (3).
Setting up the table
1. Release the stand buckle (3).
2. Unfold the wider leg set and lock the latches (2) in
place.
3. With the wider leg set touching the ground, lift the
saw up and unfold the narrower leg set.
4. Push the latches downward and lock into place.
Make sure the saw is stable and locked in position
before operation.
Fig. Q-2
3
1
FOLDING
SET-UP
SETTING UPAND FOLDINGTABLE (FIG. Q-2)
Max. load 300 Ibs.
1. Do not stand on, sit, or use for a ladder.
2. Make sure all four legs are locked firmly in place
before using the saw.
3. Injury may occur if the user does not follow
the proper procedures and warnings.
Injury may occur if the user does not follow
proper procedures.
Loading ...
Loading ...
Loading ...