Loading ...
Loading ...
Loading ...
Additional blade adjustments (Fig. K)
1. If the front and rear measurements are not the
same, remove the combination square and loosen
the four adjusting screws (1) on the top of the table
about a half turn.
2. With a folded piece of cardboard covering the
blade to protect your hands, move the blade and
motor mounting rod carefully to the left or right as
much as needed to align the blade correctly.
3. Tighten the four screws (1) and re-measure, as
described in steps 4 to 9 in the prior section.
4. If sufficient adjustment cannot be made by the four
adjusting screws (1), then also loosen the two
adjusting screws (2) and repeat all previous steps.
Loosen these screws only if necessary at they are
set for accurate 90 ° and 45° settings.
5. Recheck blade clearance making sure that the
blade does not hit the table insert or other parts
when at the 90° and 45° settings..
6. Re-tighten all four adjusting screws (1) and reset
the 90° and 45 ° setting as stated on page 13.
Fig. K
\
INSTALLING THE PUSH-STICK STORAGE (FIG. L)
Attach the push-stick storage (1) into the right side of
the body shell.
Fig. L
4
1
STORAGE (FIG. L, M)
Rip fence and miter gauge (Fig, L)
Storage brackets for the rip fence (3) and miter gauge
(4) are located on the right side of the saw housing.
Blade (Fig. M)
1. Loosen and remove the knob (1) on the left side
of the saw housing.
2. Place extra blades onto the arbor. Replace the
knob and tighten.
Fig. M
INSTALLING THE TABLE INSERT (FIG. M-l)
The table insert has been previously installed on your
unit. However, you must verify that the table insert is
flush with the table top surface on all four corners of
the insert.
If the table insert is not flush with the table, adjust the
four bolts (1) with a 4mm hex. wrench until it is
parallel with the table. Note: To raise the insert, turn
the hex screws counterclockwise, to lower the insert,
turn the hex screws clockwise.
Fig. M-1 1
]4
Loading ...
Loading ...
Loading ...