True Residential TUI15ROPD 15" Overlay Panel Right-Hinge Clear Ice Machine

INSTALL GUIDE AND USER’S MANUAL - Page 27

For TUI15ROPD.

PDF File Manual, 56 pages, Read Online | Download pdf file

TUI15ROPD photo
Loading ...
Loading ...
Loading ...
15 INCH TRUE
ICE
TM
MACHINE INSTALL GUIDE
TEC_TM_073 | REV. D | EN
12/03/2021 Page 27 of 56
LEVELING ICE MACHINE
1. Set unit in its final location. Be sure there is
adequate ventilation in your room.
2. Proper leveling of your True unit is critical to
operating success. Effective drainage and door
operation will be affected by leveling. Adjust leg
levelers on the front and back of the cabinet if
needed to level the unit.
3. The unit should be leveled from the top of the unit
front to back and side to side with a level. If the
ice machine is not level adjust the stainless steel
leg levelers. The leg levelers can be adjusted by
turning to reach the desired leveling height as
shown in the illustration above.
4. Free plug and cord from back of ice machine
(do not plug in).
5. The unit should be placed close enough to
the electrical supply so that extension cords
are never used.
6. Once installed in final location, attach kickplate to
the magnets on the front of the unit.
WARNING: COMPRESSOR WARRANTIES ARE VOID
IF THE UNIT IS MORE THAN SEVEN FEET (2.1 M)
FROM PLUG-IN CONNECTION OR IF AN
EXTENSION CORD IS USED.
WATER SUPPLY
Locate the water supply.
The water supply line should be connected to the
house supply with an easily accessible shut-off valve
between the water supply and the ice machine. A
reverse osmosis system can be used, provided there
is constant water pressure of 20 psi (1.4 bar) to 80
psi (5.5 bar) supplied to the ice machine at all times.
A copper line is not recommended for this application.
CAUTION: WATER PRESSURE MUST BE BETWEEN
20 PSI (1.4 BAR) AND 80 PSI (5.5 BAR).
A REVERSE OSMOSIS SYSTEM CAN BE USED,
PROVIDED THE WATER PRESSURE STAYS
WITHIN THE REQUIRED RANGE ABOVE. IF THE
WATER PRESSURE EXCEEDS THE MAXIMUM
PRESSURE, INSTALL A WATER PRESSURE
REGULATOR.
A cold water supply line must be supplied to the ice
machine. Use 1/4" OD copper, braided stainless steel
or PEX tubing and compression fittings (not included).
The incoming water temperature must remain between
40°F (4°C) and 100°F (38°C).
Do not connect the ice machine to a hot water supply.
Be sure all hot water restrictors installed for other
equipment are working, such as check valves on sink
faucets, dishwashers, etc.
Insulate the water supply line to prevent condensation.
ELECTRICAL & PLUMBING
ELECTRICAL PLUMBING
Voltage: 115/60/1
Water Supply: 1/4” O.D. copper,
braided stainless steel or PEX tub-
ing and compression fittings (not
included)
Drain Pump Connection: Supplied
with 7’ (2.13 m) of 3/8” O.D. plastic
tubing
Min Circuit Ampacity (amps): 15
Power Cord Length: 8' (2.4 m)
Annual kWh Consumption:
9.5 kwh/100 lb
Loading ...
Loading ...
Loading ...