Loading ...
Loading ...
Loading ...
iCE & WATER
Icemaker is not Refrigerator was recently installed or It may take up to 24 hours for each compartment to
making ice. icemaker recently connected, reach the desired temperature and for the icemaker to
begin making ice.
Icemaker not turned on. Locate the icemaker ON/OFF switch and confirm that
it is in the ON (I) position.
The ice detecting sensor is obstructed. Foreign substances or frost on the ice-detecting sensor
can interrupt ice production. Make sure that the sensor
area is clean at all times for proper operation.
The refrigerator is not connected to Connect the refrigerator to the water supply and turn
a water supply or the supply shutoff: the water shutoff: valve fully open.
valve is not turned on.
Ice has bad taste or
odor.
Icemaker is making
too much ice.
Icemaker shutoff: (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected to your cold
water supply.
Water supply contains minerals such
as sulfur.
If your icemaker is equipped with an ice shutoff: arm,
make sure that the arm moves freely. If your icemaker
is equipped with the electronic ice shutoff: sensor,
make sure that there is a clear path between the two
sensors.
Reverse osmosis filtration systems can reduce the
water pressure below the minimum amount and result
in icemaker issues. (Refer to the Water Pressure
section.)
A water filter may need to be installed to eliminate
taste and odor problems.
NOTE: In some cases, a filter may not help. It may not
be possible to remove all minerals / odor / taste in all
water supplies.
Icemaker was recently installed. Discard the first few batches of ice to avoid discolored
or bad tasting ice.
Ice has been stored for too long. Ice that has been stored for too long will shrink,
become cloudy, and may develop a stale taste. Throw
away old ice and make a new supply.
The food has not been stored Rewrap the food. Odors may migrate to the ice if
properly in either compartment, food is not wrapped properly.
The interior of the refrigerator needs See the Care and Cleaning section for more
to be cleaned, information.
The ice storage bin needs to be Empty and wash the bin (discard old cubes). Make
cleaned, sure that the bin is completely dry before reinstalling
it.
Icemaker shutoff: (arm/sensor) is
obstructed.
Empty the ice bin. If your icemaker is equipped with
an ice shutoff: arm, make sure that the arm moves
freely. If your icemaker is equipped with the electronic
ice shutoff: sensor, make sure that there is a clear path
between the two sensors. Reinstall the ice bin and wait
24 hours to confirm proper operation.
44
1 MFL67855601 Eng.indd 44 2013.7.25 8:52:1 AM
Loading ...
Loading ...
Loading ...