Loading ...
Loading ...
Loading ...
Setting the C ock
The _ pad is used to set the dock, The dock may be set for 12 or 24 hour time of
day
operation, The dock has been preset at the factory for the 12 hour operation, When the range
is first pUugged in, or when the power suppUyto the range has been interrupted, the timer in
the dispUay wHUflash aUong with "PF" (power failure, See Figure 1),
When PF appears in the dispUay and 12:00 is flashing, press }. No sound wHUbe
heard,
but after 10 seconds a beep wHUsound and PF wHUdisappear,
Figure 1
mNSTRUCTmONS PRESS DISPLAY
To set the clock (example below for 1:30)
1, Press _moc_. "CLO" wHUappear in the
dispUay (Figure 2),
2,
Press pads to set the time of day to 1:30 (Figure 3),
"CLO" will stay in the display, Press @. "CLO" will disappear
and the clock will start (Figure 4),
Changing between 12 or 24 hour time of day display
1, Press and hold _loc_ for 7 seconds (Figure 3), After 7 seconds,
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display
and the control will beep once,
Press _l_ to switch between the 12 and 24 hour time of
2,
day
d
display, The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6),
___ for 7 seconds
Figure 2
Figure 3
Figure 4
3,
4,
Press to accept the change or press to reject the
change,
Reset the correct time as described in To set the Clock above,
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours,
18
Figure 5
Figure 6
Loading ...
Loading ...
Loading ...