Dewalt DWE402 TYPE 2 angle grinder

User Manual - Page 17

For DWE402.

PDF File Manual, 71 pages, Download pdf file

Loading ...
Loading ...
Loading ...
1.Allowthetooltoreachfullspeedbeforetouchingtooltothework
surface.
2.Applyminimumpressureto work
surface,allowingthetooltooperate FIG.14
at highspeed.Sandingrate is
greatestwhenthetooloperatesat
highspeed. _......_15o
3.Maintaina5° to15° anglebetween
the tooland worksurface.The
sandingdisc should contact
approximately1"(25.4mm)ofwork
surface.
4.Movethetoolconstantlyinastraightlinetopreventburningand
swirlingofworksurface.Allowingthetoolto restonthework
surfacewithoutmoving,ormovingthetoolinacircularmotion
causesburningandswirlingmarksontheworksurface.
5.Removethetoolfromworksurfacebebreturningtooloff.Allow
thetooltostoprotatingbeforelayingitdown.
MOUNTING AND REMOVING HUBBED WHEELS (FIG. 15)
Hubbed wheels install directly on the 5/8"-11 threaded spindle.
Thread of accessory must match thread of spindle.
1. Remove backing flange by pulling FIG.15
away from tool.
2. Thread the wheel on the spindle (E) by
hand.
3. Depress the spindle lock button and
use a wrench to tighten the hub of the
wheel.
4. Reverse the above procedure to
remove the wheel.
NOTICE: Failure to properly seat the
wheel before turning the tool on may result
in damage to the tool or the wheel.
Precautions To Take When Sanding Paint
1. Sanding of lead based paint is NOT RECOMMENDED due to
the difficulty of controlling the contaminated dust. The greatest
danger of lead poisoning is to children and pregnant women.
2. Since it is difficult to identify whether or not a paint contains
lead without a chemical analysis, we recommend the following
precautions when sanding any paint:
PERSONAL SAFETY
1. No children or pregnant women should enter the work area
where the paint sanding is being done until all clean up is
completed.
2. A dust mask or respirator should be worn by all persons entering
the work area. The filter should be replaced daily or whenever the
wearer has difficulty breathing.
NOTE: Only those dust masks suitable for working with lead paint
dust and fumes should be used. Ordinary painting masks do not
offer this protection. See your local hardware dealer for the proper
N.I.O.S.H. approved mask.
3. NO EATING, DRINKING or SMOKING should be done in the work
area to prevent ingesting contaminated paint particles. Workers
should wash and clean up BEFORE eating, drinking or smoking.
Articles of food, drink, or smoking should not be left in the work
area where dust would settle on them.
ENVIRON M ENTAL SAFETY
1. Paint should be removed in such a manner as to minimize the
amount of dust generated.
2. Areas where paint removal is occurring should be sealed with
plastic sheeting of 4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint
dust outside the work area.
16
Loading ...
Loading ...
Loading ...