Dewalt DWE402 TYPE 2 angle grinder

User Manual - Page 15

For DWE402.

PDF File Manual, 71 pages, Download pdf file

Loading ...
Loading ...
Loading ...
3.Whiledepressingthespindlelockbutton,threadthelocking
flange(H)onspindle.Ifthewheelyouareinstallingismorethan
1/8"(3.17mm)thick,placethethreadedlockingflangeonthe
spindlesothattheraisedsection(pilot)fitsintothecenterofthe
wheel.Ifthewheelyouareinstallingis 1/8"(3.17mm)thickor
less,placethethreadedlockingflangeonthespindlesothatthe
raisedsection(pilot)isnotagainstthewheel.
4.Whiledepressingthespindlelockbutton,tightenthelocking
flangewithawrench.
5.Toremovethewheel,depressthespindlelockbuttonandloosen
thethreadedlockingflangewithawrench.
NOTE" If the wheel spins after the threaded locking flange is
tightened, check the orientation of the threaded locking flange. If a
thin wheel is installed with the pilot on the locking flange against the
wheel, it will spin because the height of the pilot prevents the locking
flange from holding the wheel.
FIG.9
uv_-H 1/8" (3.17 mm) 1/8" OR LESS
WHEELS (3.17 mm) WHEELS
LOCKING FLANGE
LOCKING FLANGE
BACKING FLANGE BACKING FLANGE
SURFACE GRINDING WITH GRINDING WHEELS (FIG. 10)
1. Allow the tool to reach full speed before touching the tool to the
work surface.
2. Apply minimum pressure to the work surface, allowing the tool
to operate at high speed. Grinding rate is greatest when the tool
operates at high speed.
3. Maintain a 20 ° to 30 ° angle between the tool and work surface.
4. Continuously move the tool in a FIG.10
forward and back motion to avoid
creating gouges in the work surface.
5. Remove the tool from work surface _..... 20°_30°
before turning tool off. Allow the
tool to stop rotating before laying it
down.
EDGE GRINDING WITH GRINDING WHEELS (FIG. 11)
_CAUTION: Wheels used for edge grinding and cutting may break
or kick back if they bend or twist while the tool is being used. In all
edge grinding/cutting operations, the open side of the guard must be
positioned away from the operator. Edge grinding/cutting with a
Type 27 wheel must be limited to shallow cutting and notching--less
than 1/2" (13 mm) in depth when the wheel is new. Reduce the depth
of cutting/notching equal to the reduction of the wheel radius as it
wears down. Refer to pages 10 and 11 for more information. Edge
grinding/cutting with a Type 1 wheel requires usage of a Type 1 guard.
1. Allow the tool to reach full speed
before touching the tool to the work
surface.
2. Apply minimum pressure to the work
surface, allowing the tool to operate at
high speed. Grinding rate is greatest
when the tool operates at high speed.
3. Position yourself so that the open-
underside of the wheel is facing away
from you.
4. Once a cut is begun and a notch is
established in the workpiece, do not
change the angle of the cut. Changing
14
Loading ...
Loading ...
Loading ...