Loading ...
Loading ...
Loading ...
24
PRE-OPERATION
Once the stove has been properly installed and
plugged into a grounded surge protector, you are
ready to begin operation.
PRIOR TO STARTING
Turn on the main power switch located on the
back of the stove. See Figure 20A
NOTE: If for some reason the stove does not
appear to be powering on, there is a fuse
located just below the power switch that can be
checked. A spare fuse is located inside the
fuse holder if needed. See Figure 20B
Make sure the hopper is clean and free of
foreign matter, including pellet fines and dust.
Fill the hopper with wood pellets, making sure
that NO parts of the bag or any foreign objects
enter the hopper, as this may cause harm to
the auger feed system. See Figure 21
Also take care to ensure there is no pellet
material in the hopper lid seating surfaces.
Close the lid. This stove has a safety switch
that will not allow pellets to feed with the
hopper door open.
Ensure the main glass door is closed. This
stove has a safety switch that will not allow
pellets to feed unless there is a negative
pressure detected inside the stove.
Before actually starting your stove, you will
need to determine which operating mode you
would prefer the stove to run in. This stove can
operate in one of three modes.
Manual: In this mode, you can personally adjust
and set the heating power level to control the
heat level.
Thermostat Control (Temp): In this mode, you
can set the room temperature and the stove will
automatically adjust the heating power level to
maintain the desired temperature.
Weekly: In this mode, the stove will work
automatically during days and times you
predesignate. You can have a program for
each of the 7 days of the week, and up to 4
periods during the day.
You must select your mode before turning on the
stove.
Selecting a mode while the stove is burning may
cause the stove to shut down and may force a 30-
minute delay in restarting. You do not need to start
operation of the stove to select your mode. To
choose the mode, locate the mode transfer button
on the controller. (#6 in Figure 17)
Pressing the mode button once selects Temp
mode, pressing twice will select the Weekly mode,
pressing a third time will return you back to
Manual mode.
1.
2.
3.
WARNING
Never use flammable liquids such as gasoline,
gasoline-type lighter fuel, charcoal, lighter
fluid, or fire starting gels in or around the
stove. Keep all such liquids well away from
the stove when it is in use.
Never open the side panels or main door when
stove is in operation.
Never touch door latches while in operation,
they can get extremely hot.
Never open glass door while stove is operating
or while stove is hot.
Figure 20A: Power Switch Figure 20B: Spare Fuse
Figure 21: Pellet Load Hopper Lid
Loading ...
Loading ...
Loading ...