Loading ...
Loading ...
Page 3 of 4
ASSEMBLY INSTRUCTIONS (continued)
1. Press the locking tab of the mounting plate and slide the
light fixture(A) up to detach the light fixture (A) from
mounting plate.
2. Remove the battery cover on the back of the light fixture
and remove the old batteries.
3. Install three new 1.5V AA batteries into the battery
compartment. Make sure the polarity of the batteries is
correct.
4. Restore the battery cover.
5. Place the guide slot of the light fixture over the mounting
plate and slide the fixture down onto the mounting plate
until the locking tab clicks and locks the light fixture into place.
AA Battery
Battery Cover
Notes:
1. The sensitivity of the motion sensor will increase as the environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to assure maximum sensitivity.
2. The fixture will provide a detection distance of up to 25 feet. (See Fig.2)
3. The sensor detects movement across a detection range of 120 degrees. (See Fig.3)
4. The sensor will be more sensitive to motion across its detection path than motion directly towards it. (See Fig.4)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or other light source.
1.5V AA
1.5V AA
1.5V AA
Fig. 1
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig.4
6. Place the guide slot of the
light fixture(A) over the
mounting plate and slide the
fixture(A) down onto the
mounting plate until the
locking tab clicks and locks
the light fixture(A) into place.
Battery Replacement
Note: Properly dispose of drained batteries.
6
A
Locking
Tab
Guide Slot
5`
6`
10`
25`
Fig. 2 Fig. 3
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
otherwise, the detection distance may be limited.
˚
120
Loading ...