Loading ...
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Safety Glasses, Ladder,
Electric Drill.
Page 2 of 4
PREPARATION
ASSEMBLY INSTRUCTIONS
Important to know
1. No wiring required
2. Use three 1.5V AA batteries (not included)
Recommend to use Menards SKU number:
Energizer / 2105370 in Menards store or
more than 2200mAH 1.5V AA lithium battery.
3. Easy to install
4. 120 lumen LED output
5. Wall mount only
1. Press the locking tab of the
mounting plate and slide the
mounting plate from the light
fixture(A).
2. Hold the mounting plate to the
wall and mark the set holes on
the wall surface for drilling.
Remove the mounting plate
from the wall. Drill both holes.
Thread the anchors(BB) into
the holes, and then attach the
mounting plate to the wall,
secure the drywall screws(AA)
through the set holes into the
anchors(BB).
6.
Power switch setting:
a.) Set the switch to OFF position: the power turns
off.
b.) Set the switch to ON position: light turns to
sensor mode. Turn light on automatically when
motion is detected and turn it off automatically when
motion stops.Photocell keeps the light OFF during
daylight.
Installation Steps
2
Mounting
Plate
AA
BB
1
Mounting Plate
Locking Tab
A
A
3. Pull out the locking tab of
battery cover to open the
battery cover and then
remove the battery cover from
the back plate (B).
4. Install three 1.5V AA batteries
(not included) into the battery
compartment. Make sure the
polarity of the batteries is
correct. Restore the battery
cover.
NOTE: Recommend to use
more than 2200mAH 1.5V AA
lithium battery for extreme
climate and long life span.
5. Press the power switch to the
ON position to activate the
motion sensor.
Note: When power is first
applied, the light will turn
on immediately. Wait for
about 30 seconds to allow
the sensor to warm up.
When motion is detected, the
light will turn on. The light will
stay on for a period of 10
seconds after all motion has
stopped.
SAFETY INFORMATION
1. Please read and understand this entire manual before attempting to assemble, operate or install the product.
2.
Integrated LED: 3 W
Working Temperature Range of Sensor: -4ºF ~ 104ºF
B
3
Locking
Tab
Battery
Cover
4
5-a
B
ON / OFF
Power Switch
5-b
B
A
Sensor
Light
Loading ...
Loading ...