Loading ...
Loading ...
Loading ...
2.
Position the drawer assembly in front of the housing
assembly and align the rail (plastic rail tip) to the slide
ball carrier assembly. Keeping the drawer assembly
level and square to the housing, gently insert the
drawer to the housing assembly.
Notes
▯ A slight side-to-side wiggle motion may be required
to properly get the ball bearings to accurately align.
▯ Remember: You are attempting to align two sets of
ball bearings at this point. If more than a moderate
force is required to insert the drawer at this time,
remove the drawer and repeat the installation
procedure to this point.
3.
Continue to insert the drawer keeping the drawer level
and square to the housing until a slight increase in
resistance is felt at the approximate position shown
below.
English 38
NOTICES
▯ At this position, a slight increase in closure force is
required with several small increments of force
applied to the drawer to accurately align and set the
drawer for proper operation.
▯ An audible “click” should be heard when the drawer
is properly closed causing the drawer to lock in the
closed position.
4.
Test the operation of the PTO drawer by pushing on
the center lower portion of the drawer front (optimum
location for function).
Note: It should be noted the recommended and
optimum location for opening the drawer is the lower
center front. The drawer will operate with an opening
force applied to any location on the drawer front,
however a slight increase in opening force may be
required.
2SWLPXPORFDWLRQIRU372IXQFWLRQ
Loading ...
Loading ...
Loading ...